Essential braking system parts may break down after operating for a certain duration. Unfortunately, repairing such parts individually can be extremely costly. For this reason, one may prefer to seek brake change services to remedy the problem for good.
This article will highlight the crucial steps of efficiently changing a braking system.
5 Vital Steps for Effective Brake Change
1. Remove the Wheel and The Slider Bolt
Please start by disconnecting the nuts with a wrench before lifting the car with a jack. After that, you should remove the wheel with a chock intact to prevent the vehicle from rolling back during wheel removal.
2. Lift the Brake Caliper a Bit.
Secondly, the mechanic should extract the lower bolt before lifting the brake caliper to a reasonable height. The rubber hose can flex to enable you to check the brake pads’ condition.
The good news is that the repairer won’t have to disengage the respective brake lines. Squeaking is a sign that the brake pads are completely worn out and must be replaced.
3. Remove the Worn-Out Brake Pads.
A pair of clips hold the brake pads together for the braking system to function well. Therefore, the repair expert will have to remove the old brake parts for replacement. You’ll need new retaining clips to connect new brake pads.
4. Check the Brake Fluid Level.
A replacement technician should detect a brake fluid rise if they shove the pistons in position. For this reason, he should monitor the cylinder reservoir as often as possible.
A brake fluid level must never go under the MIN arrow and shouldn’t be excessive. After that, you should re-adjust the caliper on the new brake pads.
5. Attach a New Slider Bolt.
Please install a new slider bolt and tighten it well before mounting the tire. After that, secure the lug nuts to hold the respective wheel in position.
When is the Appropriate Time for Brake Change?
Each braking system features brake pad sensors that alert a car owner when these parts wear out. Good braking pads should be at least 6.4 millimeters to avoid exposing the metal part. Therefore, the sensor flashes light when the pads’ width decreases past this limit.
Therefore, the vehicle owner should consider getting brake pad replacement services.
Conclusion
Unknown to many, brakes may impede wheel rotation, making it harder to drive a car. For this reason, a mechanic might recommend brake change services to replace the brake pads. Drivers shouldn’t ignore the brake pad sensor’s warning to replace these parts before it gets too late.